Virtual and physical testing of systems
Lesson 5 / 16
Lesson video
The video is not available yet.
Lesson slides
not available yet
Lesson details
Lesson outcome
I can virtually and physically test a control system.
Show transcript
Testing electronic circuits and control systems is often referred to as fault finding.
A multimeter is used to measure current, voltage, resistance in both virtual and physical circuits and control systems.
Resistance and voltage are measured in parallel but current is measured in series.
Virtual and physical test results will differ due to the tolerance of physical components and test equipment.
Worksheet
not available yet
Quizzes
This quiz is not available yet.
What pupils see
The same lesson as a pupil sees it. You can set any section as work on its own.
- IntroductionPrepare · Not available
- Starter quizActivate · Not available
- Lesson videoLearn · Not available
- Exit quizCheck · Not available
This content is by Cashar and published under an open licence.